How to fix bad taste or odor in Diamond Coral WATERBAR-S Water Filtration Systems water?
If the water from your Diamond Water Filtration System has a bad taste or odor, clean the water tank and refill it with fresh, purified water. Then, flush the machine with 2-3 cups of hot water.
Why is the water flow not smooth in Diamond Water Filtration Systems?
If the water flow in your Diamond Water Filtration System is not smooth, it could be due to the water tank not being installed correctly after a refill. Ensure that the electric cable is not bent and is properly installed under the water tank adapter.
What to do if the Diamond Coral WATERBAR-S Water Filtration Systems power button is blinking red?
If the power button on your Diamond Water Filtration System is blinking red, it likely means the water tank is low. Refill the water tank to resolve this issue.
Why is the hot water function not working on my Diamond Water Filtration Systems?
There are a couple of reasons why the hot water function on your Diamond Water Filtration System might not be working: * First, check if the hot water is locked. Gently press the ON button to unlock it. * Second, make sure the hot water button is turned “ON” and the hot water button is turn “green.”
What to do if Diamond Coral WATERBAR-S Water Filtration Systems is leaking from the bottom?
If you notice water leaking from the bottom of your Diamond Water Filtration System, the water tank adapter's tube may not be installed correctly. Check the tube and reinstall it to ensure a proper fit.
What to do if hot, warm, or normal water automatically stops in Diamond Water Filtration Systems?
If the hot, warm, or normal water function on your Diamond Water Filtration System stops automatically, the water tank adapter might not be installed properly. Unplug the water tank adapter and reinstall it. If the problem persists, please contact customer service.
Why does my Diamond Coral WATERBAR-S Water Filtration Systems splash on the first cup?
A sudden splashing from your Diamond Water Filtration System on the first cup typically occurs if the filter water level was allowed to reach minimum before refilling. This is a temporary phenomenon caused by air or bubble tracks inside the hose. The water splash expels these bubbles.
What to do if there is no water flow out of Diamond Coral WATERBAR-S Water Filtration Systems?
If there is no water flowing out of your Diamond Water Filtration System, make sure the silicone plug is properly inserted.
How to turn on the hot water function on Diamond Coral WATERBAR-S?
To enable the hot water function on your Diamond Water Filtration System, ensure the hot water is unlocked by gently pressing the ON button. Also, confirm that the hot water button is turned "ON" and the indicator light is green.
General| Product Name | Diamond Coral WATERBAR-S |
|---|---|
| Category | Water Filtration Systems |
| Filtration Stages | 5 |
| Filtration Method | Reverse Osmosis |
| Stages of Filtration | 5 |
| Warranty | 1 year |
| Filter Life | 12 months |
| Daily Production Capacity | 75 gallons |
| Included Components | User manual |
Details the initial cleaning process for the water tank.
Instructions on dispensing hot, warm, and normal water.
Guide on how to clean the drip tray and inner disk.
Safety measures during operation and when the device is not in use.
Provides additional tips and reminders for optimal usage.
To Next Page