Anomaly
THE ICE MAKER REMAINS WITHOUT WATER IN THE MIDDLE OR AT
THE END OF THE CYCLE
Cause Remedy
Dirty spray nozzles Clean or replace the spray nozzles
Water leakage from the basin Check possible breakings
Filter of the water inlet valve clogged Clean the filter
Anomaly THE ICE MAKER DOESN’T SPRAY WATER
Cause Remedy
The pump is out of order
Check the electric and mechanical pump efficiency
or replace it
Filter of the pump suction clogged Clean the filter
Limestone inside the pump pipes Clean the pipes from the limestone
Spray nozzles clogged Clean the spray nozzles
Anomaly THE ICE MAKER DOESN’T STOP WHEN THE BIN IS FULL
Cause Remedy
Bin thermostat
Replace the thermostat or adjust it or check the
probe position
Anomaly
THE ICE MAKER STOPS BY INTERVENTION OF THE WATER
CONDENSER SAFETY THERMOSTAT / PRESSURE-SWITCH
(Water Leakage in the Condenser)
Cause Remedy
No water supply to the ice maker Check the water supply
The water inlet valve doesn’t open
• Check the correct working of the
thermostat / pressure-switch
• Check if the correct rated voltage reaches
the water inlet valve
• Replace the valve
Condenser clogged by limestone Remove the limestone from the condenser
To Next Page
Loading...