TWS (True Wireless Stereo) Button
This controls the TWS (True Wireless Stereo)
system on the DiamondBoxx. This is used to con-
nect two DiamondBoxx 2nd generation or later
together wirelessly in a split stereo pair for an
amazing, headphone like stereo experience.
To USE TWS System
1. Start with both DiamondBoxxes powered OFF.
2. Power up one of the DiamondBoxx, pair your Blue-
tooth device with it. Start streaming some music to it.
3. Power up the 2nd DiamondBoxx
4. Now go back to the 1st DiamondBoxx, press and
hold the TWS button until the Diamond starts flashing
BLUE then release button. This will set this Diamond-
Boxx to “MAIN” speaker which will receive and play
LEFT audio only.
5. Now go to the 2nd DiamondBoxx, press and hold
the TWS button until the Diamond starts flashing
GREEN then release button. This will set this
DiamondBoxx to “SECONDARY” speaker which will
receive and play RIGHT audio only.
6. Wait for up to 2 minutes for the DiamondBoxxes to
configure themselves and form a secure connection.
NOTE: The maximum distance between the MAIN and
SECONDARY DiamondBoxxes should be less than 50
feet with a unobstructed path of each other. If
obstructions like walls and human bodies exist
between the two DiamondBoxxes the max range
could be shorter than 50 feet.
Tip: Raising the DiamondBoxxes off the ground/floor
may help extend the range.
8. If the TWS linking procedure didn’t work, press and
hold the TWS button until the Diamond turns RED,
this will CLEAR the TWS memory. Do this to both
units and start procedure again from Step 1.
To Next Page
Loading...
