Digi TransPort LR54 - Hotspot Page

Web reference Hotspot page
Digi TransPort WR Routers User Guide
297
Hotspot page
Use the Hotspot page to configure a hotspot for a LAN.
See Hotspot for more information about configuring a hotspot.
General options
Option Description
Enable Enables or disables the hotspot. The default is disabled.
LAN Specifies which LAN to run the hotspot on. You can select any LAN on your TransPort
device to serve as the hotspot LAN; however, once you configure a LANfor use as
the hotspot LAN, you can no longer access the device's web interface or SSHserver
via that LAN. Therefore, you must make sure that you do not enable hotspot for the
LAN that you are using to access the device for other purposes, such as configuring
and monitoring the device, or providing clients with non-hotspot access to your
network.
The default is lan2.
Login Specifies whether the login page is a Local page or a Remote URL.
n Local Page—Uses an HTMLpage for authentication that is stored locally on
the TransPort device's filesystem, in the hotspot directory. Note that the
hotspot directory is not visible until hotspot has been enabled for the first
time.
n Remote URL—Uses an HTML page for authentication that is stored
remotely.
Default is Local page.
Local
page/Remote
URL
If Login is set to:
n Local Page—Specifies the local page. Normally, this field should be left blank,
and the TransPort device will use the default authentication HTMLpage
based on the selected Auth Mode. If you upload a custom HTML file that
uses a filename other than the default filename, you should select the
custom filename here.
n Remote URL—Enter the URL of the server that hosts the HTML
authentication page. The URL must begin with http:// or https://. The server
listed here must also be included in the Allowed Domains or Allowed
Subnets.
IP address Specifies the IPv4 address on which the hotspot runs, as well as the IP addresses
assigned to clients. This IPv4 address must not exist within a current subnet.
Specify the IPv4 address. The default is 10.1.0.1.
Subnet mask Specifies IPv4 subnet mask for the hotspot to assign addresses within. Specify the
subnet mask. The default is 255.255.255.0.