Web reference Interfaces—cellular page
Digi TransPort WR Routers User Guide
300
Interfaces—cellular page
Use the Cellular interface page to create and manage cellular interfaces.
Option Description
Cellular1 or Cellular 2
Description Description for the interface. Specify a string value up to 255 characters long.
SIM(s)
APN
Specifies the Access Point Name (APN) for the cellular interface. Enter a string up to
63 characters long.
Username
Specifies the username for the APN. Enter a string up to 63 characters long.
Password
Specifies the password for the APN. Enter a string up to 128 characters long.
Preferred
mode
Specifies the preferred mode for the cellular interface: Auto, 4G, 3G, or 2G. The default
is Auto.
Connection
attempts
Specifies the number of attempts to establish a cellular connection. After this number
of attempts, the cellular module is power cycled, and the device attempts to make a
cellular connection again. Enter an integer from 10 to 500. The default is 20.
Cellular status and statistics
Option Description
WAN For SIMs, displays the WAN to which the cellular interface is assigned.
Oper status Displays the operational status for the cellular interface: Up or Down.
SIM status Displays the SIM (SIM1 or SIM2) in use for this cellular module.
Signal
quality
Displays an indicator of the quality of the received cellular signal measured in dB.
Signal
strength
Displays a measure of the signal level of the cellular network measured in dB.
IP address Displays the IP address for the cellular interface.
Mask Displays the address mask for the cellular interface.
Gateway Displays the IP address of the remote end of the cellular connection.
DNS servers Displays the DNS server(s) associated with the cellular interface.
TX bytes Displays the number of bytes transmitted by the cellular interface.
RX bytes Displays the number of bytes received by the cellular interface.
To Next Page
Loading...
