Web reference New Wide Area Network (WAN) page
Digi TransPort WR Routers User Guide
317
New Wide Area Network (WAN) page
Use the New Wide Area Networks (WAN) page to configure a new WAN.
New WAN connection
Option Description
Select WAN Select an available index number for the new WAN.
Select interface Select an available interface for the WAN.
Enable Enable or disable the network. The default is Enabled.
Configuration options—cellular
Option Description
Select
WAN
Select an available index number for the new WAN.
Select
interface
Select an available interface for the WAN.
Enable Enable or disable the network. The default is Enabled.
IPv6
Enable
IPv6
Enable or disable IPv6 addressing. The default is disabled.
Requested
prefix
length
Specifies the length, in bits, of the IPv6 address prefix to request from the upstream
router for this WAN. The size of the prefix determines how many LANs can support
IPv6. Request a prefix length of 60 bits or less to support up to 16 LANs. Enter an
integer from 48 to 64. The default value is 60.
Security
Allow
HTTPS
Enable or disable HTTPS access for the WAN. The default is Disabled.
All SSH
Enable or disable SSH access for the WAN. The default is Disabled.
Probing
Probe
host
Specifies the IPv4 or fully qualified domain name (FQDN) of the address of the device
itself. The WAN failover feature sends probe packets over the WAN to the IP address of
this device. Value should be a fully qualified domain name.
Probe
interval
Specifies the interval, in seconds, between sending probe packets. The value for must
be larger than the Probe timeout value. If not, the WAN failover configuration is
considered invalid, and an error message is written to the system log. Accepted value
is any integer from 2 to 3600. The default value is 60.
To Next Page
Loading...
