Digi TransPort LR54 - Port Forwarding Page

Web reference Port forwarding page
Digi TransPort WR Routers User Guide
329
Port forwarding page
Use the Port forwarding page to configure and view port forwarding rules. Each port forwarding rule
automatically maps and forwards an external request for a port on a WAN to an IP address and port
on an internal LAN. In this way, users can access servers on a private network when they are not
directly connected to the private network.
For a port forwarding rule to be applied, you must configure From Port and To IPAddress, and set
the rule to Enabled. You can configure a maximum of 30 port forwarding rules.
Configuration options
Each port forwarding rule shows the following fields:
Option Description
Enabled Enables or disables the port forwarding rule. The default is enabled.
Note Invalid rules are not applied.
Description Description for the rule. Specify a string value up to 255 characters long.
From Port Port or ports to forward packets from. A port is an integer value from 0 to 65535. The
default is 0.
Specify a single port, a list of ports, or a range of ports:
n To specify a list of ports, use a comma (,) to separate the ports in the list. For
example: 443,22,31.
n To specify a range of ports, use a colon (:) to separate the low and high ports in
the range. For example: 22:31.
Source Source WAN or LAN of incoming traffic to be forwarded. Select Any, Any-LAN, Any-WAN,
or an available LAN or WAN. The default is Any.
Protocol Protocol to which the rule applies: UDP, TCP, or UDP and TCP. The default is TCP.
To
IPaddress
IP address in IPv4 format that packets are forwarded to.
To Port Port to forward packets to. A port is an integer value from 0 to 65535. Enter a port
number or the Use from port(s) option to map the ports specified by From Port as
the To Port. The default is Use from port(s).