Digi TransPort LR54 - Quality of Service (Qos) Queues Page

Web reference Quality of Service (QoS) queues page
Digi TransPort WR Routers User Guide
331
Quality of Service (QoS) queues page
Use the Quality of Services (QoS) queues page to manage QoS queues.
Configuration options
Configure from one to eight QoS queues using the eight tabs in the Queues panel. Queue 1 has the
highest priority; queue 2 has second-highest priority, queue 3 has third-highest priority, and so on up
to queue 8 which has the lowest priority.
Field/Button Description
Enabled
Enables or disables the QoS queue. The default is disabled.
Description
Specifies a description for the QoS queue that displays as the tab label for
the queue. Specify a string value up to 255 characters long.
Bandwidth upstream
Specifies the amount of bandwidth this queue can use in Kbps or Mbps.
For Kbps, enter an integer from 0 to 1000000; for Mbps, enter an integer
from 1 to 1000. The default is 0.
Borrow upstream
Enables (allows) or disables (prohibits) additional bandwidth for this queue
if any unused bandwidth is available. The default is enabled.
Tag packet (DSCP)
Tags packets with a specified Differentiated Services Code Point (DSCP).
Select a value from the drop-down list. The default is do not set; that is,
do not tag packets.
QoS filters
Field/Button Description
Enabled
Enables or disables the QoS filter. For a new filter, the default is enabled.
Description
Specifies a description for the QoS filter. Specify a string value up to 255
characters long.
Queue
Specifies the queue number to associate with the QoS filter. Specify an
integer from 1 to 8, corresponding to queue 1, queue 2, queue 3, and so on.
The default is 0 or the current queue being edited.
Protocol
Specifies the protocols for incoming packets. Select one or more specific
protocols from the drop-down or select any to include all protocols. The
default is any.
Src
Specifies the source LAN or LANs of incoming packets. Select a specific LAN
from the drop-down list or specify any to include all LANs. The default is
any.
Src IP
Specifies the IPv4 or IPv6 source address of incoming packets. Use a
simple IPv4 or IPv6 address or use CIDR notation. For example,
192.168.100.0/24, fe80::/10.