Digi TransPort LR54 - Digi Remote Manager Page

Web reference Digi Remote Manager page
Digi TransPort WR Routers User Guide
336
Digi Remote Manager page
Use the Digi Remote Manager page to configure the TransPort device connection to Digi Remote
Manager. For information on Digi Remote Manager, see Digi Remote Manager.
Administration options
Option Description
Enable
Enables or disables connection to Digi Remote Manager for this device. The default is
disabled.
Ethernet
keepalive
Specifies the Ethernet keepalive timeout in seconds. Enter an integer from 10 to
7200. The default is 60.
Cellular
keepalive
Specifies the cellular keepalive timeout in seconds. Enter an integer from 10 to 7200.
The default is 290.
Keepalive
count
Specifies the number of times a keepalive message is missed before the Remote
Manager connection is dropped. Enter an integer from 2 to 10. The default is 3.
Reconnect
delay
Specifies the the time, in seconds, between the device's attempts to connect to Digi
Remote Manager. Enter an integer from 10 to 3600. The default is 30.
Enable
health
reporting
Enables or disables Digi Remote Manager health reporting for this device. The default
is enabled.
Health
sample
interval
Specifies the sample interval in minutes: 1, 5, 15, 30, or 60. The default is 60.
Register device
Option Description
Username Specifies the Digi Remote Manager username.
Password Specifies the password for the Digi Remote Manager user.
Status display
Option Description
Status Shows the current Digi Remote Manager status: Connected or Disconnected.
Up time Shows the amount of time the device has been connected to Digi Remote Manager.
Device ID Shows the Digi Remote Manager ID for the device.