Web reference Wide Area Network (WAN) page—Ethernet
Digi TransPort WR Routers User Guide
343
Wide Area Network (WAN) page—Ethernet
Use the Wide Area Networks (WAN) page to configure and manage WANs.
Configuration options—Ethernet
Option Description
Enable
Enables or disables the network. The default is Enabled.
IPv4
Configure
using
Specifies configuration method: Manually or DHCP. The default is DHCP.
IP address
For manually configured WAN only. Specifies the IPv4 address for the WAN.
Netmask
For manually configured WAN only. Specifies the IPv4 netmask for the WAN.
Gateway
For manually configured WAN only. Specifies the IPv4 gateway address for the WAN.
DNS1
For manually configured WAN only. Specifies the IPv4 address for the primary DNS
server.
DNS2
For manually configured WAN only. Specifies the IPv4 address for the secondary DNS
server.
IPv6
Enable
IPv6
Enables or disables IPv6 addressing. The default is disabled.
Requested
prefix
length
Specifies the length, in bits, of the IPv6 address prefix to request from the upstream
router for this WAN. The size of the prefix determines how many LANs can support
IPv6. Request a prefix length of 60 bits or less to support up to 16 LANs. Enter an
integer from 48 to 64. The default value is 60.
Security
Allow
HTTPS
Enables or disables HTTPS access for the WAN. The default is Disabled.
Allow SSH
Enables or disables SSH access for the WAN. The default is Disabled.
Probing
Probe
host
Specifies the IPv4 or fully qualified domain name (FQDN) of the address of the device
itself. The WAN failover feature sends probe packets over the WAN to the IP address of
this device. Value should be a fully qualified domain name.
Probe
interval
Specifies the interval, in seconds, between sending probe packets. The value for must
be larger than the Probe timeout value. If not, the WAN failover configuration is
considered invalid, and an error message is written to the system log. Accepted value
is any integer from 2 to 3600. The default value is 60.
To Next Page
Loading...
