Digi TransPort LR54 - Hotspot

Command reference hotspot
Digi TransPort WR Routers User Guide
381
hotspot
Configures the hotspot feature on this device. This feature forces all clients connecting over the
specified LAN to authenticate before they can access the WAN interface.
Syntax
hotspot <parameter> <value>
Parameters
state
Enables or disables the hotspot.
Value is either on or off. The default value is off.
auth-mode
The method used to authenticate hotspot clients.
Accepted values can be one of click-through, local-shared-password, radius-shared-password, radius-
users or hotspotsystem. The default value is click-through.
local-shared-password
Password used when 'auth-mode' is set to 'local-shared-password'.
Accepted value is any string up to 64 characters.
lan
Specifies which LAN to run the hotspot on. When a user attempts to make a connection to any of the
network interfaces that are part of this LAN they will be redirected to the login page for
authentication before they can access the WAN resources.
Accepted values can be one of lan1, lan2, lan3, lan4, lan5, lan6, lan7, lan8, lan9 or lan10. The default
value is lan2.
radius-server1
The IP address or fully-qualified domain name of the RADIUS server to use to authenticate hotspot
users.
Value should be a fully qualified domain name.
radius-server2
The IP address or fully-qualified domain name of the backup RADIUS server to use to authenticate
hotspot users.
Value should be a fully qualified domain name.
radius-server-port
The UDP port number for the RADIUS server.
Accepted value is any integer from 1 to 65535. The default value is 1812.