Digi TransPort LR54 - Ipsec

Command reference ipsec
Digi TransPort WR Routers User Guide
387
ipsec
Configures an IPsec tunnel. Up to 32 IPsec tunnels can be configured.
Syntax
ipsec <1 - 32> <parameter> <value>
Parameters
state
Enables or disables the IPsec tunnel.
Accepted values can be one of off or on. The default value is off.
description
A description of this IPsec tunnel.
Accepted value is any string up to 255 characters.
peer
The remote peer for this IPsec tunnel.
Value should be a fully qualified domain name.
esp-authentication
The Encapsulating Security Payload (ESP) authentication type used for the IPsec tunnel.
Accepted values can be multiple values of sha1, sha256 and sha384. The default value is sha1.
esp-encryption
ESP encryption type for IPsec tunnel
Accepted values can be multiple values of aes128, aes192, aes256, aes128gcm64, aes192gcm64,
aes256gcm64, aes128gcm96, aes192gcm96, aes256gcm96, aes128gcm128, aes192gcm128 and
aes256gcm128. The default value is aes128.
esp-diffie-hellman
The Encapsulating Security Payload (ESP) Diffie-Hellman group used for the IPsec tunnel.
Accepted values can be multiple values of none, group5, group14, group15, group16 and group20. The
default value is group14.
auth-by
The authentication type for the IPsec tunnel
Accepted values can be one of psk or xauth-psk. The default value is psk.
psk
The preshared key for the IPsec tunnel.
Accepted value is any string up to 128 characters.