Digi TransPort LR54 - Port-Forward

port-forward
Digi TransPort WR Routers User Guide
410
port-forward
Configures port forwarding rules.
Syntax
port-forward <1 - 30> <parameter> <value>
Parameters
port
The TCP or UDP port or ports from which incoming packets are forwarded.
Accepted value is any string up to 255 characters.
to-port
The TCP or UDP port that packets are forwarded to after being received on the incoming port(s).
Accepted value is any integer from 0 to 65535. The default value is 0.
to-ip-address
The IPv4 address that packets are forwarded to after being received on the incoming interface.
Value should be an IPv4 address.
description
The description of this rule.
Accepted value is any string up to 255 characters.
state
Enables or disables a port forward rule. Invalid rules are not enabled.
Value is either on or off. The default value is off.
protocol
The protocol or protocols of the packets to forward.
Accepted values can be one of tcp, udp or tcp-and-udp. The default value is tcp-and-udp.
src
The WAN or LAN that is the source of incoming traffic to be forwarded.
Accepted values can be one of any, any-lan, lan1, lan2, lan3, lan4, lan5, lan6, lan7, lan8, lan9, lan10, any-
wan, wan1, wan2, wan3, wan4, wan5, wan6, wan7, wan8, wan9 or wan10. The default value is any.