Digi TransPort LR54 - Page 490

wan
Digi TransPort WR Routers User Guide
490
probe-size
Size of probe packets sent to detect WAN failures.
Accepted value is any integer from 64 to 1500. The default value is 64.
activate-after
The time, in seconds, that the primary interface needs to be up before switching back to it as the
active interface. If probing is active, no probes are permitted to be lost during this period. Otherwise,
the timer is restarted.
Accepted value is any integer from 0 to 3600. The default value is 0.
retry-after
The time, in seconds, to wait before retrying this interface after failing over to a lower priority one.
Use a large retry timeout when both interfaces are cellular interfaces.
Accepted value is any integer from 10 to 3600. The default value is 180.
dhcp
Enables or disables the DHCP client. The DHCP client is used to automatically get an IP address for
the interface from a DHCP server.
Value is either on or off. The default value is on.
ip-address
The IPv4 address to be statically assigned to this WAN if DHCP is disabled.
Value should be an IPv4 address.
mask
The IPv4 mask to be statically assigned to this WAN if DHCP is disabled.
Value should be an IPv4 address. The default value is 255.255.255.0.
gateway
The gateway to use for the default route.
Value should be an IPv4 address.
dns1
The IPv4 address of the preferred DNS server. This value overrides the value assigned by DHCP.
Value should be an IPv4 address.
dns2
The IPv4 address of the alternate DNS server used if the device cannot communicate with the
preferred server.
Value should be an IPv4 address.
allow-ssh-access
Allow SSH access on this WAN interface. Custom firewall rules may affect the behavior of this
parameter.
Value is either on or off. The default value is off.