EasyManua.ls Logo

Digi TransPort WR11 - Page 280

Digi TransPort WR11
948 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring network interfaces Configure ISDN interfaces
Digi TransPor Routers User Guide
280
Use a.b.c.d as the local IP address for this router
If it is essential that the PPP interface has a specific IP address, this radio button should be
selected and the IP address entered into the text box.
Use the following DNS servers if not negotiated
Primary DNS server
The IP address of the primary DNS server to use if a DNS server is not assigned as part of the
PPP negotiation and connection process. It is fairly common practice for the DNS server to be
assigned automatically by the ISP when making a connection.
Secondary DNS server
The IP address of the secondary DNS server to use if one is not automatically assigned by the
remote peer.
Attempt to assign the following IP configuration to remote devices
When checked, this check box reveals the following four configuration parameters which
control how the PPP instance assigns an IP address to a connecting remote peer. The primary
and secondary DNS server addresses will also be sent to the remote peer
Assign remote IP addresses from a.b.c.d to a.b.c.d
The IP addresses that define the pool of IP addresses to assign to remote peers during the IP
protocol configuration phase of the PPP negotiation process.
Primary DNS server
The IP address of the primary DNS server that the remote peer should use when making DNS
requests over the link.
Secondary DNS server
The IP address of the secondary DNS server that the remote peer should use when making
DNS requests, should the primary server be unavailable.
Allow the PPP interface to answer incoming calls
When enabled, causes the PPP instance to answer an incoming call.
Only allow calling numbers ending with n
When set to answer calls, this setting provides a filter for ISDN sub-addresses. This value is
blank by default but when the PPP instance is set to answer calls, only numbers having trailing
digits that match the sub-address value in this test will be answered. So for example, if this
value is set to 123, only calls from numbers with trailing digits that match this value will be
answered; for example, 01942 605123.
Enable NAT on this interface
Enables Network Address Translation to operate on this interface. This is the same as for other
PPP interfaces.
IP address/IP address and Port
Whether IP address translation only should be applied or whether port number translation
should also be applied to IP packets.

Table of Contents

Other manuals for Digi TransPort WR11

Related product manuals