Digi TransPort WR11 - Page 296

Configuring network interfaces Configure PSTN interfaces
Digi TransPort® Routers User Guide
296
Command Instance Parameter Values
Equivalent web
parameter
ppp n IPaddr 0.0.0.0 Allow the remote device to
assign a local IP address to
this router
ppp n IPaddr Valid IP address
a.b.c.d
Try to negotiate a.b.c.d as
the local IP address for this
router
(in conjunction with l_addr)
ppp n l_addr off, on
When on, allows
negotiation
when off, force
use of specified IP
address
Use a.b.c.d as the local IP
address of this router
ppp n DNSserver Valid IP address
a.b.c.d
Use the following DNS
servers if not negotiated
Primary DNS server a.b.c.d
ppp n secDNS Valid IP address
a.b.c.d
Use the following DNS
servers if not negotiated
Secondary DNS server
a.b.c.d
ppp n IPmin Valid IP address
a.b.c.d
Assign remote IP addresses
from a.b.c.d to a.b.c.d
ppp n IPrange 0-255 Assign remote IP addresses
from a.b.c.d to a.b.c.d
ppp n transDNS Valid IP address
a.b.c.d
Primary DNS server a.b.c.d
ppp n sectransDNS Valid IP address
a.b.c.d
Secondary DNS server
a.b.c.d
ppp n ans off, on Allow this PPP interface to
answer incoming calls
ppp n cingnb up to 25 digits Only allow calling numbers
ending with n
ppp n do_nat 0, 1, 2
0=Disabled
1=IP address
2=IP address and
port
Enable NAT on this interface
IP address/IP address and
Port
ppp n nat_ip Valid IP address
a.b.c.d
NAT Source IP address
a.b.c.d