Digi TransPort WR11 - Page 330

Configuring network interfaces Configure serial interfaces
Digi TransPort® Routers User Guide
330
Connect to host a.b.c.d Port n
The IP address or hostname and TCP port that the router should use when making a device
initiated connection.
Allow s seconds between connection attempts
The interval, in seconds, between device initiated connection attempts.
Send TCP Keep-Alives every s seconds
The interval at which TCP Keep-Alives are sent over the RealPort connection. A value of 0
means that Keep-Alives are not sent.
Send RealPort Keep-Alives every s seconds
The interval at which RealPort Keep-Alives are sent over the RealPort connection. A value of 0
means that Keep-Alives are not sent.
Enable exclusive mode
Enables exclusive mode. Exclusive mode allows a single connection from any one RealPort
client ID to be connected only. If this setting is enabled and a subsequent connection occurs
that has the same source IP as an existing connection, the old existing connection is forcibly
reset under the assumption that it is stale.
Enable authentication
Enables RealPort authentication.
Authentication secret
Configures the RealPort authentication secret.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
rport 0 enabled off, on Enable RealPort
rport 0 ipport 0-65535 Listen on port n
rport 0 maxnbsocks 0-255 Maximum number of sockets
rport 0 encryption off, on Enable encrypted RealPort
rport 0 encport 0-65535 Encryption mode to listen on
port
rport 0 maxnbencsocks 0-255 Maximum number of encryption
sockets
rport 0 initiate off, on Enable Device Initiated RealPort
rport 0 IPaddr Valid IP address
a.b.c.d
Connect to host a.b.c.d Port n