Digi TransPort WR11 - Page 362

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
362
second box contains the time in seconds for which the data rate must be below threshold before the
second B-channel is deactivated.
Note The following parameters are for use with Always On Dynamic ISDN.
Bring up the first ISDN B-channel
When the data rate is greater than n bytes/sec for s seconds
When Always On mode is enabled, these two settings specify the data rate and duration for which the
data rate must be sustained before the B-channel is activated.
Drop the first ISDN B-channel
When the data rate is less than n bytes/sec for s seconds
When Always On mode is enabled, these two settings specify the data rate below the traffic must fall
and the duration for which it is below the threshold before the B-channel is deactivated.
Command line
Command Instance Parameter Values Equivalent web parameter
mlppp 0 l_accm 0x00000000-
0xFFFFFFFF
Desired local ACCM
mlppp 0 r_accm 0x00000000-
0xFFFFFFFF
Desired remote ACCM
mlppp 0 username Valid username username
mlppp 0 password Valid password password
mlppp 0 epassword Encrypted
password
None-this parameter is not
configurable
mlppp 0 r_chap on, off Enable remote CHAP
authentication
mlppp 0 l_shortseq on, off
Default off
Enable short sequence
numbers
mlppp 0 up_rate 0-2147483648
Default 2000
When the data rate is
greater than n bytes/sec
mlppp 0 up_delay 0-2147483648
Default 10
for s seconds
mlppp 0 down_rate 0-2147483648
Default 1000
When data rate is less than n
bytes/sec
mlppp 0 down_delay 0-2147483648
Default 10
for s seconds
mlppp 0 dup_rate 0-2147483648
Default 500
When data rate is greater
than n bytes/sec