EasyManua.ls Logo

Digi TransPort WR11 - Page 367

Digi TransPort WR11
948 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring network interfaces Configure PPP and external modems
Digi TransPor Routers User Guide
367
Secondary DNS server
The IP address of the secondary DNS server that the remote peer should use when making
DNS requests, should the primary server be unavailable.
Request packet data connection
When enabled, causes the PPP instances to request a connection for sending a data packet.
Allow the PPP interface to answer incoming calls
When enabled, causes the PPP instance to answer an incoming call.
Only allow calling numbers ending with n
When set to answer calls, this setting provides a filter for ISDN sub-addresses. This value is
blank by default but when the PPP instance is set to answer calls, only numbers having trailing
digits that match the sub-address value in this test will be answered. So for example, if this
value is set to 123, only calls from numbers with trailing digits that match this value will be
answered, for example, 01942 605123.
Close the PPP connection after s seconds
The maximum time that the link will remain active in any one session. After this time, the link
will be deactivated.
if it has been up for m minutes in a day
The router deactivates the PPP instance after it has been active for the value specified in this
text box.

Table of Contents

Other manuals for Digi TransPort WR11

Related product manuals