Digi TransPort WR11 - Page 370

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
370
Command Instance Parameter Values
Equivalent web
parameter
ppp n l2face The lower layer
interface, such as.
LAPB, LAPD, XOT
This PPP interface will
use
ppp n l2nb Lower layer
interface number.
Default: 0
ppp n aodinua
ppp n phonenum up to 25 digits Dial out using numbers
ppp n ph2 up to 25 digits Dial out using numbers
ppp n ph3 up to 25 digits Dial out using numbers
ppp n ph4 up to 25 digits Dial out using numbers
ppp n prefix 0-9999999999 Prefix n to the dial out
number
ppp n username Valid username Username
ppp n password Valid password Password
ppp n epassword The encrypted
password
None-this parameter is
not configurable
ppp n r_addr Default 0.0.0.0 set
automatically
Allow the remote device
to assign a local IP
address to this router
ppp n IPaddr Valid IP address
a.b.c.d
Try to negotiate a.b.c.d
as the local IP address
for this router
ppp n l_addr Valid IP address
Default 1.2.3.4
Use a.b.c.d as the local
IP address for this router
ppp n mask Valid IP address
Default
255.255.255.255
Use mask a.b.c.d for this
interface
ppp n DNSserver Valid IP address Primary DNS server
ppp n secDNS Valid IP address Secondary DNS server
ppp n DNSport Valid IP address
Default 53
DNS Port
ppp n IPmin Valid IP address
Default 10.10.10.10
Assign remote IP
addresses from a.b.c.d to
a.b.c.d