Digi TransPort WR11 - Page 371

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
371
Command Instance Parameter Values
Equivalent web
parameter
ppp n IPrange 0-255
Default 5
Assign remote IP
addresses from a.b.c.d to
a.b.c.d Note that these
are not directly
equivalent. This address
is obtained by adding the
range value to the
minimum.
ppp n transDNS Valid IP address Primary DNS server
ppp n sectransDNS Valid IP address Secondary DNS server
ppp n cingnb up to 25 digits Only allow numbers
ending with n
ppp n msn up to 9 digits with ISDN MSN ending
with n
ppp n sub up to 17 digits with ISDN sub-address
ending with n
cli
ppp n maxup 0-2147483648 Close the PPP
connection after s
seconds
ppp n maxuptime 0-2147483647 if it has been up for m
minutes in a day
ppp n timeout Default 300s (5
minutes)
if it has been idle for h,
m, s
ppp n timeout2 0-2147483648 Alternative idle timer for
static routes s seconds
ppp n rxtimeout 0-2147483648 if the link has not
received any packets for
s seconds
ppp n maxneg 0-2147483648 if the negotiation is not
complete in s seconds
ppp n do_nat 0, 1
0=Off
1=On
Enable NAT on this
interface
ppp n natip Valid IP address
a.b.c.d
NAT Source IP address
a.b.c.d
ppp n ipsec 0, 1
0=Off
1=On
Enable IPsec on this
interface