Digi TransPort WR11 - Page 372

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
372
Command Instance Parameter Values
Equivalent web
parameter
ppp n Keep Security
Associations (SAs) when
this PPP interface is
disconnected
ppp n ipsecent Default
PPP
Ethernet
Use interface x,y for the
source address of IPsec
packets
ppp n ipsecadd Valid interface
number
Use interface x,y for the
source address of IPsec
packets
ppp n firewall off, on Enable the firewall on
this interface
ppp n qos off, on Enable QoS on this
interface
ppp n use_modem 0, 1 This PPP interface will
use
ppp n cdma_backoff 0, 1
Default: 1
None
ppp n ndis off, on Request packet data
connection
ppp nocfg 0, 1, 2, 3 Remote management
access
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management
and return RST
ppp n igmp off, on Enable IGMP
ppp n ifspeed 64000 bps None. CLI command only.
The ppp command
allows configuring the
interface speed for
reporting in SNMP.
ppp n norxrst off, on None
ppp n vrf integer None. CLI command only.
ppp n vrfexport integer None. CLI command only.