Digi TransPort WR11 - Page 483

Configuring Virtual Private Networking (VPN) Configure Internet Protocol security (IPsec)
Digi TransPort® Routers User Guide
483
Command Instance Parameter Values Equivalent web parameter
eroute n privkey Filename RSA Key File.
eroute n espenc off, null, des, 3des, aes Use enc encryption on this tunnel.
eroute n enckeybits 128, 192, 256 Use enc encryption on this tunnel.
eroute n espauth off, md5, sha1 Use auth authentication on this
tunnel.
eroute n dhgroup 0, 1, 2, 3 Use Diffie Hellman group.
eroute n ikever 1, 2 Use IKE n to negotiate this
tunnel.
eroute n ikecfg 0, 1 Use IKE configuration.
eroute n autosa 0=On Demand
1=When a route to the
destination is available
2=All the time
Bring this tunnel up.
eroute n nosa drop, pass, try If the tunnel is down and a packet
is ready to be sent.
eroute n inact_to Integer Bring this tunnel down if it is idle
for h hrs m mins s secs.
This CLI value is entered in
seconds only.
eroute n ltime Integer Renew the tunnel after h hrs m
mins s secs.
This CLI value is entered in
seconds only.
eroute n lkbytes Integer Renew the tunnel after n units of
traffic.
This CLI value is entered in Kbytes
only.
Configure IPsec tunnel negotiation parameters
Entity Instance Parameter Values Equivalent web parameter
eroute n debug on, off Enable IKE tracing
eroute n neglocip IP Address Negotiate a different IP address and Mask
eroute n neglocmsk IP Mask Negotiate a different IP address and Mask
eroute n vip on, off Negotiate a virtual IP address using MODECFG
eroute n xauthid String XAuth ID