Digi TransPort WR11 - Page 611

Configuring legacy protocols Configure TPAD parameters
Digi TransPort® Routers User Guide
611
Command Instance Parameter Values
Equivalent web
parameter
tpad n tenqdel 0-5000 Delay sending ENQ
characters to TPAD
terminal for x
milliseconds when a call
has been connected.
tpad n tackdel 0-10000 Wait for x milliseconds for
an ACK before
retransmitting the data.
tpad n dsync 1=enabled, 0=disabled Transmit TPAD
transactions directly in a
Synchronous frame.
tpad n inclrc 1=enabled, 0=disabled Include LRC.
tpad n incllrc 1=enabled, 0=disabled Include LRC line.
tpad n fpar 1=enabled, 0=disabled Force parity when
sending data to the
terminal.
tpad n lrpar 1=enabled, 0=disabled Strip parity when sending
data to the host.
tpad n lfpar 1=enabled, 0=disabled Force parity when
sending data to the host.
tpad n strip_
tspaces
1=enabled, 0=disabled Strip Trailing Spaces.
tpad n ackdat 1=enabled, 0=disabled Acknowledge TPAD data
packets.
tpad n stx_2_soh 1=enabled, 0=disabled Convert leading STX
character to SOH.
tpad n eot_only 1=enabled, 0=disabled Terminate TPAD call is
EOT only.
tpad n tresp 0–1000 Clear TPAD call if there is
no response to a TPAD
transaction request for x
seconds.
tpad n texcess 0–100 Generate an event when
a TPAD transaction takes
longer than x seconds