Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
637
n To stop PAD 1 from processing PAD commands:
st oppads 1
n To re-enable PAD 1:
gopads 1
X3 parameters
Each PAD configuration page has an attached sub-page that allows you to edit the X.3 PAD
parameters. These pages allow you to load one of the standard profiles or edit the individual
parameters to suit your application requirements and save the resulting customized user profile to
non-volatile memory.
Loading and saving PAD profiles
To create your own PAD profiles, edit the appropriate parameters and then select user profile 1, 2, 3
or 4 as required from the list and click the Save Profile button. Each PAD profile page includes two list
boxes for loading and saving PAD profiles. To load a particular profile, select the profile from the list
and click the Load Profile button. The parameter table is updated with the values from the selected
profile.
To Next Page
Loading...
