Digi TransPort WR31 - Page 157

Configure network interfaces Configure Ethernet interfaces
Digi TransPort WR Routers User Guide 157
eth n dmnr_reg on, off Enable DMNR advertisement from this subnet
eth n nocfg 0, 1, 2, 3 Remote management access
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management and return RST
eth n mhome 0-255 Multihome additional consecutive addresses
eth n igmp 0, 1 Enable IGMP on this interface
eth n bridge 0, 1 Enable Bridge on this interface
eth n heartbeatip IP address Send Heartbeat messages to IP address a.b.c.d
every h hrs m mins s seconds
eth n hrtbeatint 0-86400 Send Heartbeat messages to IP address a.b.c.d
every h hrs m mins s seconds
This CLI value is entered in seconds only.
eth n hbipent blank, eth, ppp Use interface x,y for the source IP address
x=Interface type
eth n hbipadd 0-255 Use interface x,y for the source IP address
y=interface number
eth n hbroute 0, 1 Select the transmit interface using the routing
table
eth n hbimsi 0, 1 Include IMSI information in the Heartbeat
message
Entity Instance Parameter Values Equivalent web parameter