Digi TransPort WR31 - Page 208

Configure network interfaces Configure mobile (cellular) interfaces
Digi TransPort WR Routers User Guide 208
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
ppp 1 metric 0-256 Metric
ppp 1 off, on Generate Heartbeats on this interface
ppp 1 hrtbeatip IP address Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s secs
ppp 1 hrtbeatint 0-2147483647
(seconds)
Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s secs
ppp 1 hbipent Default,PPP,Ethernet Use interface x,y for the source IP address
ppp 1 hbipadd number Use interface x,y for the source IP address
ppp 1 hbroute on/off Select transmit interface using the routing
table
ppp 1 hbimsi on/off Include IMSI information in the Heartbeat
message
ppp 1 hbgps on/off Include GPS information in the Heartbeat
message
ppp 1 off, on Generate Ping packets on this interface
ppp 1 pingsiz number Send n byte pings to IP host a.b.c.d every h
hrs m mins s secs
ppp 1 pingip IP addressd Send n byte pings to IP host a.b.c.d every h
hrs m mins s secs
ppp 1 pingint 0-2147483647
(seconds)
Send n byte pings to IP host a.b.c.d every h
hrs m mins s secs
ppp 1 pingint2 0-2147483647
(seconds)
Send pings every h hrs m mins s secs if
ping responses are not being received
ppp 1 pingip2 IP address Switch to sending pings to IP host a.b.c.d
after n failures
ppp 1 ip2count number Switch to sending pings to IP host a.b.c.d
after n failures
ppp 1 pingresp 0-2147483647 Ping responses are expected within n
seconds
ppp 1 pingis on/off Only send Pings when this interface is In
Service
ppp 1 ping2cont on/off New connections to resume with previous
Ping interval