EasyManua.ls Logo

Digi TransPort WR31 - Page 237

Digi TransPort WR31
866 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configure network interfaces Configure ISDN interfaces
Digi TransPort WR Routers User Guide 237
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
ppp n metric 0-255 Metric
ppp n aodion 0-2
0=disabled
1=enabled
2=On and return
to service
immediately
Enable “Always On” mode of this interface,
On, On and return to service immediately
ppp n immoos on, off Put this interface “Out of Service” when an
always-on connection attempt fails
ppp n aodi_dly 0-2147483647 Attempt to reconnect after s seconds
ppp n aodi_dly2 0-2147483647 If an inhibited PPP interface is connected,
attempt to re-connect after s seconds
ppp n pwr_dly 0-2147483647 Wait s seconds after power-up before
activating this interface
ppp n tband 0-4 Control when this interface can connect
using Time Band n
ppp n minup 0-2147483647 Keep this interface up for at least s seconds
ppp n maxup 0-2147483647 Close this interface after s seconds
ppp n maxuptime 0-2147483647 if it has been up for m minutes in a day
ppp n timeout 0-2147483648 if the link has been idle for s seconds
ppp n timeout2 0-2147483648 Alternative idle timer for static routes s
seconds
ppp n rxtimeout 0-2147483648 if the link has not received any packets for s
seconds
ppp n maxneg 0-2147483648 if the negotiation is not complete in s seconds
ppp n uplogmins 0-2147483647 Generate an event after this interface has
been up for m mins
ppp n dlwarnkb 0-2147483647 Issue a warning after n units
ppp n dlstopkb 0-2147483647 Stop data from being transmitted after n
units
ppp n dlrstday 0-255 Reset the data limit on the n day of the month

Table of Contents

Other manuals for Digi TransPort WR31

Related product manuals