Configure network interfaces Configure ISDN interfaces
Digi TransPort WR Routers User Guide 244
Stop data from being transmitted after n units
The total amount of data that may be transmitted by this PPP instance before the link is blocked
for further traffic, and the value in the drop-down list specifies the units which are kilobytes,
megabytes, gigabytes.
Reset the data limit on the n day of the month
The day of the month on which the data limit is reset to 0.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
ppp n metric 0-255 Metric
ppp n aodion 0-2
0=disabled
1=enabled
2=On and return to
service immediately
Enable “Always On” mode of this interface, On, On
and return to service immediately
ppp n immoos on, off Put this interface “Out of Service” when an
always-on connection attempt fails
ppp n aodi_dly 0-2147483647 Attempt to reconnect after s seconds
ppp n aodi_dly2 0-2147483647 If an inhibited PPP interface is connected, attempt
to re-connect after s seconds
ppp n pwr_dly 0-2147483647 Wait s seconds after power-up before activating
this interface
ppp n tband 0-4 Control when this interface can connect using
Time Band n
ppp n minup 0-2147483647 Keep this interface up for at least s seconds
ppp n maxup 0-2147483647 Close this interface after s seconds
ppp n maxuptime 0-2147483647 if it has been up for m minutes in a day
ppp n timeout 0-2147483648 if the link has been idle for s seconds
ppp n timeout2 0-2147483648 Alternative idle timer for static routes s seconds
ppp n rxtimeout 0-2147483648 if the link has not received any packets for s
seconds
ppp n maxneg 0-2147483648 if the negotiation is not complete in s seconds
ppp n uplogmins 0-2147483647 Generate an event after this interface has been up
for m mins
ppp n dlwarnkb 0-2147483647 Issue a warning after n units
To Next Page
Loading...
