Digi TransPort WR31 - Page 257

Configure network interfaces Configure PSTN interfaces
Digi TransPort WR Routers User Guide 257
ppp n do_nat 0, 1, 2
0=Disabled
1=IP address
2=IP address and
port
Enable NAT on this interface
IP address/IP address and Port
ppp n nat_ip Valid IP address
a.b.c.d
NAT Source IP address a.b.c.d
ppp n ipsec 0=Disabled
1=Enabled
2=Enabled and
Keep SAs
Enable IPsec on this interface/
Keep Security Associations when this PSTN
interface is disconnected
ppp n firewall off, on Enable the firewall on this interface
Entity Instance Parameter Values Equivalent web parameter