Digi TransPort WR31 - Page 285

Configure network interfaces Configure serial interfaces
Digi TransPort WR Routers User Guide 285
Escape delay s milliseconds
The delay required between entering the escape sequence (default +++) and the AT command
for the router to drop back into command mode. This is equivalent to the S12 register setting.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
transip n port Valid port number 0-65535 Listen on port
transip n host Valid IP address a.b.c.d or
hostname
Connect to IPaddress a.b.c.d or
Hostname
transip n remport Valid port number 0-65535 Port
transip n keepact 0-255 Send TCP Keep-Alives every s
seconds
transip n staycon on, off Enable Stay Connected mode
transip n cmd_echo_off on, off Disable command echo
transip n escchar Valid ASCII character Escape char c
transip n esctime 0-255 Escape delay s milliseconds