Digi TransPort WR31 - Multitx Parameters

Configure network interfaces Configure serial interfaces
Digi TransPort WR Routers User Guide 289
MultiTX parameters
The MultiTX page is for enabling and setting the MultiTX parameters. This page supports sending
serial data to multiple (up to 5) TCP or UDP destinations. When enabled, the configured ASY port is
opened and serial data from the port is sent to all configured destinations.
Enable Multitx
When enabled, displays the MultiTX settings in the web interface and enables the MultiTX
function on the router.
Serial Port
The serial interface to use. Data received on this serial will be forwarded to all configured remote
hosts.
Protocol
Selects the transport method: either TCP or UDP.
Socket Inactivity Timeout
If there is no data transmitted for the specified number of seconds, the socket will be closed.
0=no timeout.
Source port
The source port number.
Send Socket ID
When enabled, the text entered into the Socket ID field is transmitted to the remote host when
the socket connects.