Configure network interfaces Configure Advanced interfaces settings: External modems and PPP
Digi TransPort WR Routers User Guide 318
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
ppp n metric 0-255 Metric
ppp n settledly 0-200 Allow this PPP interface to settle for s
seconds after the connection has
come up
ppp n aodion 0, 1, 2
0=disabled
1=enabled
2=On and return
to service
immediately
Enable “Always On” mode of this
interface, On, On and return to service
immediately
ppp n autoassert 0, 1, 2
0=no autoassert
1=autoassert with
route up delay
2=autoassert with
no route up delay
ppp n immoos on, off Put this interface “Out of Service”
when an always-on connection
attempt fails
ppp n rdoosdly on, off remote disconnect
ppp n aodi_dly 0-2147483647 Attempt to reconnect after s seconds
ppp n aodi_dly2 0-2147483647 If a PPP interface that would be
inhibited by this PPP is connected,
attempt to re-connect after s seconds
ppp n pwr_dly 0-2147483647 Wait s seconds after power-up before
activating this interface
ppp n minup 0-2147483647 Keep this interface up for at least s
seconds
ppp n multi off, on Enable Multilink PPP on this interface
ppp n netip Valid IP address
a.b.c.d
Add a route to a.b.c.d if the peer’s IP
address is not negotiated
ppp n block_dns on, off Enable DNS inbound blocking
ppp n rbcast off, on Forward IP broadcasts over this
interface if this interface is on the same
IP network as an Ethernet interface
To Next Page
Loading...
