Digi TransPort WR31 - Page 419

Configure Virtual Private Networking (VPN) IPsec parameters
Digi TransPort WR Routers User Guide 419
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
eroute n mode tunnel, transport IPsec Mode.
eroute n ahauth off, md5, sha1 Use a AH authentication on this tunnel.
eroute n ipcompalg off, deflate Use c compression on this tunnel.
eroute n oosdelsa on, off Delete SAs when this tunnel is down.
eroute n ifvrrpmaster on, off Delete SAs when router is not a VRRP master.
eroute n nosaoos on, off Go out of service if automatic establishment
fails.
eroute n nosadeactcnt Integer Go out of service after n consecutive auto-
negotiation failures.
eroute n check_apnbu on, off This tunnel can only use apn.
eroute n apnbu 0=Main APN
1=Backup APN
This tunnel can only use apn.
eroute n ifent blank, ETH, PPP Link tunnel with interface with x,y.
x=Interface type
eroute n ifadd Integer Link tunnel with interface with x,y.
y=Interface number
eroute n inhibitno Comma-
separated list of
Integers
Inhibit this IPsec tunnel when IPsec tunnels n
are up.
eroute n requireno Integer Inhibit this IPsec tunnel unless IPsec tunnel n is
up.
eroute n usesecip on, off IKE negotiation source IP address is taken from
the Secondary IP Address.
eroute n ipent blank, ETH, PPP IKE negotiation source IP address is taken from
the Interface x,y.
x=Interface type
eroute n ipadd Integer IKE negotiation source IP address is taken from
the Interface x,y.
y=Interface number
eroute n intunnel on, off Tunnel this IPsec tunnel inside another IPsec
tunnel.
eroute n natkaint Integer NAT-Traversal Keepalive timer s seconds.
eroute n proto off, tcp, udp, gre Allow protocol IP protocol(s) in this tunnel.