Configure Virtual Private Networking (VPN) IPsec parameters
Digi TransPort WR Routers User Guide 454
Advanced IKEv2 Responder parameters
Stop IKE negotiation if no packet received for n seconds
The period of time, in seconds, after which the router will stop the IKEv2 negotiation when no
response to a negotiation packet has been received.
Enable NAT-Traversal
Enables support for NAT Traversal within IKE/IPsec. When one end of an IPsec tunnel is behind a
NAT box, some form of NAT traversal may be required before the IPsec tunnel can pass packets.
Turning NAT Traversal on enables the IKE protocol to discover whether or not one or both ends
of a tunnel is behind a NAT box, and implements a standard NAT traversal protocol if NAT is not
being performed.
The version of NAT traversal supported is that described in the IETF draft document draft-ietf-
ipsec-nat-t-ike-03.txt.
NAT traversal keep-alive interval n seconds
The interval, in seconds, in which the NAT Traversal keepalive packets are sent to a NAT device in
order to prevent NAT table entry from expiring.
RSA private key file
The name of a X.509 certificate file holding the router’s private part of the public/private key pair
in certificate exchanges. See X.509 Certificates for further explanation.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
ike2 0 inactto 0-255 Stop IKE negotiation if no packet received for n
seconds
ike2 0 natt on, off Enable NAT-Traversal
ike2 0 natkaint Integer NAT traversal keep-alive interval n seconds
ike2 0 privrsakey Filename RSA private key file
To Next Page
Loading...
