Configure legacy protocols Configure X.25 parameters
Digi TransPort WR Routers User Guide 569
Send ENQ on Connect
If set to On, the PAD sends an ENQ character on the ASY link when an outgoing call has been
answered.
Enable STX / ETX Filtering
If set to On, the PAD ignores data that is not encapsulated between ASCII characters STX
(Ctrl+B) and ETX (Ctrl+C). To disable this feature select the Off option.
Delay connect message n x 10 milliseconds
Delay the Connect message by the number of milliseconds specified. This is useful when
working with equipment previously connected to slower networks that may have difficulty
processing the quicker Connect on modern networks.
Delay data transfer after connection by n x 10 milliseconds
Delays the data delivered from the X.25 or other type of connection to the terminal upon initial
connection.
Terminate the PAD call after x seconds if there has been no data transmission
The length of time, in seconds, after which the PAD will terminate an X.25 call if there has been
no data transmission.
Disconnect the layer 2 call if there is no layer 3 call in progress for x seconds
The length of time, in seconds, after which the router disconnects a layer 2 link if there are no
layer 3 calls in progress. For LAPB sessions, this also terminates the ISDN call.
Create an event when the following data is on the PAD
A string, which if it appears in the received data causes a Data Trigger (47) event to be generated
and recorded in the event log.
Create an event when there has been no activity on the PAD for x seconds
The time, in seconds, in which if there is no activity on the PAD an event in the event log is
posted. You can use this parameter to trigger email exceptions.
To Next Page
Loading...
