Digi TransPort WR31 - Autoset Date and Time Parameters

Configure system settings Autoset Date and Time parameters
Digi TransPort WR Routers User Guide 646
Autoset Date and Time parameters
Do not auto-set the system time
This is the system default, and this radio button is selected when the router is new, unless a
different default configuration has been supplied. Click this radio button to close the SNTP or
NTP configuration pages.
Use SNTP to auto-set the system time
Selects auto-setting the system date and time through an SNTP server. this radio button
expands the page to include the SNTP settings, described below.
SNTP server
The hostname or IP address of the desired SNTP server.
Check on Power-up
When checked, causes the router to attempt to connect to the SNTP server every time it boots.
Update every h hours
The interval, in hours, the router should wait between updating the system clock.
Update randomly between s1 and s2 seconds
It is possible to use a random update interval rather than a fixed interval. There are two text-
entry boxes for this purpose. Enter the minimum interval into the left-hand box, and the
maximum desired interval into the right-hand box. Selecting the random update clears the fixed
interval.
Offset from GMT
This parameter should be set to + or - the number of hours the router’s time should be ahead or
behind Greenwich Mean Time.