Digi TransPort WR31 - Related CLI Commands

Configure security settings Command filters
Digi TransPort WR Routers User Guide 727
Related CLI commands
Enable command filtering
To enable command filtering from the command line for any particular instance of the command
interpreter, use the following command:
cmd <n> cfilton 1
The default action is to respond with the OK response. If the response needed is ERROR, use the
parameter:
cmd <n> cfilterr 1
Where n is the instance number.
Note Enclose any blank characters by double quotation marks. When substituting a command,
upper case characters are considered the same as the corresponding lowercase characters.
Entity Instance Parameter Values Equivalent web parameter
cfilter n cmd Valid command line
command
Command
cmd n cfilton 0, 1
0=Off
1=On
n/a
cmd n cfilterr 0, 1
0=Off-OK
1=On-ERROR
n/a