Manage networks and connections View network interface status
Digi TransPort WR Routers User Guide 773
IP routing table
The IP Routing Table page displays the IPv4 routing table.
Destination
The destination IP network of the route. To use the route, the destination must match the
destination IP address of an IP packet. For default routes, the destination IP network is always
0.0.0.0/0. The router uses default routes when no other route matches the destination IP
address of an IP packet.
Src Addr
When source address routing in use, to use the route, the Src Addr value must match the source
IP address of an IP packet.
Gateway
The IP address of the next router to which the IP packet will be routed to reach the destination
network. On PPP and TUN interfaces, and ETH interfaces that have the gateway configured, this
parameter can be blank.
Metric
The route metric defines the cost of the route. If CIDR routing is enabled and there are two routes
to the same destination, the router uses the route with the lower metric.
To Next Page
Loading...
