Digi TransPort WR41 - 6 Device Initialization

TransPort
®
WR41 Utility Installation Guide
Page 15
Step 2) Connect the red wire of the battery cable to the red (positive) lead on the battery.
Step 3) Connect the black wire of the battery cable to the black (negative) lead on the battery.
Note: The remaining end of the battery cable should not be connected to the power supply until the unit has
been installed in the eld.
Step 4) Connect the remaining end of the battery cable to the battery terminal on the power supply.
5.4.1 Battery Disposal
The TransPort WR41 Utility product contains a lead-acid battery. This battery must be recycled after use.
Please follow all applicable Federal, State and regional laws dictating proper recycling methods.
6 Device Initialization
When the unit is powered-up, the POWER indicator will illuminate and the unit will initiate a series of diagnostic
self-tests. During this process one or more of the other indicators will ash to show that the unit is busy. When
the ashing stops, the unit has completed its self-test diagnostics and is ready to be congured.