Digi TransPort WR41 - Page 532

Configuring Virtual Private Networking (VPN) Configure OpenVPN
Digi TransPort® Routers User Guide
532
Debug
Enables output of OVPN related debug.
3. (Optional) Click Advanced OpenVPN parameters and configure advanced settings as needed.
4. Click Apply.
Command line
Command Instance Parameter Values
Equivalent web
parameter
ovpn n descr Up to 30
characters
Description
ovpn n IPaddr Valid IP address
a.b.c.d
IP address a.b.c.d
ovpn n dest Valid IP address
a.b.c.d
Destination host a.b.c.d
ovpn n ll_ent <blank>, PPP, ETH Link socket interface x,y
x= interface type
ovpn n ll_add 0-2147483647 Link socket interface x,y
y= interface number
ovpn n ip_ent <blank>, PPP, ETH Get link socket source
address from this
interface x,y
x= interface type
ovpn n ip_add 0-2147483647 Get link socket source
address from this
interface x,y
y= interface number
ovpn n mtu 0-2147483647 MTU
ovpn n metric 0-2147483647 Metric
ovpn n do_nat 0, 1, 2
0=Off
1=Address only
2= Address and
port
NAT mode
ovpn n ipanon off, on IP analysis
ovpn n firewall off, on Firewall
ovpn n igmp off, on IGMP
ovpn n inrip off, on Include in RIP
advertisements