Digi TransPort WR41 - Page 749

Configuring remote management Use SNMP for remote management
Digi TransPort® Routers User Guide
749
Community / Confirm Community
For SNMPv1 and SNMPv2c, these settings specify the SNMPv1 or SNMPv2c community name.
Username
The SNMPv3 user name.
Authentication
The SNMPv3 authentication type: None, MD5, SHA1, or SHA256.
Authentication Password / Confirm Authentication Password
The SNMPv3 authentication password.
Encryption
The SNMPv3 encryption type: None, DES, or AES.
Encryption Password / Confirm Encryption Password
The SMPv3 encryption password.
4. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
snmp 0 enterprisetraps off, on Generate Enterprise traps
snmp 0 generictraps off, on Generate Generic traps
snmp 0 authtraps off, on Generate Authentication Failure
traps
snmp 0 vrrptraps off, on Generate VRRP traps
snmptrap 0 ipaddr IPaddress Trap Server IP Address
snmptrap 0 port network port
number
Port
snmptrap 0 version Use SNMP Version
snmptrap 0 sendinforms off, on Send "Inform Request" message
snmptrap 0 informto integer If no response, retransmit the
Inform Request message after n
seconds
snmptrap 0 informretries integer Retransmit a maximum n times
snmptrap 0 auth none, md5,
sha1, sha256
Authentication
snmptrap 0 authpassword password Authentication Password