Digi TransPort WR44 - Page 388

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
388
Remote PFC
When enabled, causes the router to ask the remote device to request Protocol Field
Compression.
Request BACP
When enabled, the router will use the Bandwidth Allocation Control Protocol (BACP) to
determine the ISDN number to dial for the seconds or third multi-link connection.
Allow remote end to request callback
When enabled, requests a callback when it dials into a remote device. The answering PPP
instance of the remote router must also be configured with the telephone number of the
calling router and a suitable username, password combination.
Allow remote end to request callback
Controls whether or not the router will respond to incoming callback requests. The options are:
n Off
n Desired
n Required
Allow this unit to authenticate using
CHAP-MD5
Selecting enabled from the drop-down menu allows the router to authenticate logins using the
CHAP MD-5 algorithm.
MS-CHAP
Selecting enabled from the drop-down menu allows the router to authenticate logins using
Microsoft’s proprietary MS-CHAP algorithm.
MS-CHAPv2
Selecting enabled from the drop-down menu allows the router to authenticate logins using
version 2 of Microsoft’s proprietary MS-CHAP algorithm.
Allow a remote unit to authenticate using
CHAP-MD5
When enabled, allows the router to authenticate with a remote unit using the CHAP-MD5
algorithm.
MS-CHAP
When enabled, allows the router to authenticate with a remote unit using Microsoft’s MS-CHAP
algorithm.
MS-CHAPv2
When enabled, allows the router to authenticate with a remote unit using version 2 of
Microsoft’s MS-CHAP algorithm.
3. Click Apply.