Digi TransPort WR44 - Page 413

Configuring network services Configure network services
Digi TransPort® Routers User Guide
413
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
addp 0 enable on, off Enable Device Discovery (ADDP)
rport 0 enabled on, off Enable RealPort
rport 0 encryption on, off Enable Encrypted RealPort
snmp n v1enable 0, 1
0=Off
1=On
Enable Network Management Protocol
> Enable SNMP v1
snmp n port Default 161 Enable Network Management Protocol
> UDP Port n
snmp n v2cenable 0, 1
0=Off
1=On
Enable Network Management Protocol
> SNMP v2c
snmp n v3enable 0, 1
0=Off
1=On
Enable Network Management Protocol
> Enable SNMP v3
sntp 0 srvr_mode on, off Enable Simple Network Time Server
(SNTP)
sntp 0 time_src 0=RTC
1=GPS
2=NTP Client
Enable Simple Network Time Server
(SNTP) > Source
services 0 SSH on, off Enable Secure Shell Server (SSH/SFTP)
services 0 ftp on, off Enable FTP Server
services 0 http on, off Enable HTTP Server
services 0 telnet on, off Enable Telnet Server
services 0 telnets on, off Enable Telnet over SSL Server
services 0 asytcp on, off Enable ASY Port Server
tcpperm ASY 0-9 -l<listening
port>
<listening
port>
ASY 0-9 Listening Port
services 0 zing on, off Enable ZING
cmd 0 rcihttp on, off Enable RCI over HTTP