Digi TransPort WR44 - Page 446

Configuring IP routing and forwarding Configure default IP routes
Digi TransPort® Routers User Guide
446
Command Instance Parameter Values Equivalent web parameter
def_route n inact2add 0-
2147483647
Make PPP n interface use the alternative idle
timeout when this route becomes available
def_route n pwr_dly 0-255 Wait for s seconds after power up before
allowing this route to activate the interface
def_route n actooslim 0-
2147483647
Mark this route as “Out Of Service” if the
interface fails to connect after n consecutive
attempts
def_route n chkoos_int 0-
2147483647
If the interface fails to connect, try again in s
seconds
def_route n chkoos_
deact
0-
2147483647
Deactivate the interface after it successfully
connects
def_route n dial_int 0-255
Default 10
Do not allow this interface to be activated by this
route for s seconds after the last activation
attempt
def_route n q1 on,off Only queue one packet whilst waiting for the
interface to connect
def_route n deact_ent Blank,PPP When this route becomes available, deactivate
the following interfaces x,y
def_route n deact_add 0-
2147483647
When this route becomes available, deactivate
the following interfaces x,y
def_route n deact_
ent2
Blank,PPP When this route becomes available, deactivate
the following interfaces x,y
def_route n deact_
add2
0-
2147483647
When this route becomes available, deactivate
the following interfaces x,y
def_route n unoos_
secs
0-
2147483647
Keep this route in service for s seconds after
OOS state is cleared
def_route n rgroup 0-255 Assign this route to recovery group n