Digi TransPort - Use the Digi Transport Command-Line Interface

Digi TransPort User Guide 111
Use the Digi TransPort command-line
interface
This section describes the basics of using the command line interface, and provides descriptions
of some key AT and application commands. It covers the following topics:
• About the Digi TransPort command line interface on page 112
• Supported command types on page 112
• Required software for using the command line on page 112
• Connect to the TransPort router from a PC on page 113
• Log in from the command line on page 113
• Commands and the active port on page 113
• When commands take effect on page 113
• View current configuration changes on page 114
• Save changes on page 114
• Establish a remote connection on page 115
• AT commands on page 116
• Application commands on page 137
Additional commands and parameters are covered in the sections on configuring features, and in
command-line examples throughout this guide.