Digi TransPort - Page 161

Configure Ethernet interfaces
Digi TransPort User Guide 161
Related CLI Commands
Entity Instance Parameter Values Equivalent Web Parameter
n/a n/a ethvlan n/a Switch to Port Isolate Mode
n/a n/a ethhub n/a Switch to Hub Mode
eth n group 0-3,255 Ethernet Hub group
eth n metric 1-16 Metric
eth n mtu 64-1500 MTU
eth n auton 0,1 Enable auto-negotiation
eth n speed 0,10,100 Speed
0=Auto
10=10-BaseT
100=100-BaseT
eth n duplex 0,1,2 Duplex
0=Auto
1=Full
2=Half
eth n maxkbps value in kbps Max Rx rate
eth n maxtkbps value in kbps Max Tx rate
eth n tcptxbuf value in bytes TCP transmit buffer size
eth n linkdeact 0-86400 Take this interface out of service after n
seconds when the link is lost
eth n do_nat 0,1,2 Enable NAT on this interface
0=Disabled
1=IP address
2=IP address and Port
eth n ipsec 0,1 Enable IPsec on this interface
eth n ipsecent blank,ETH,PPP Use interface x,y for the source IP
address of IPsec packets
x=Interface type
eth n ipsecadd 0-255 Use interface x,y for the source IP
address of IPsec packets
y=interface number
eth n firewall 0,1 Enable the firewall on this interface
eth n nocfg 0,1,2,3 Remote management access
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management
and return RST