EasyManua.ls Logo

Digi TransPort - Page 183

Digi TransPort
813 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configure Wi-Fi interfaces
Digi TransPort User Guide 183
Wi-Fi n parameters
When a Wi-Fi interface is configured to be an Access Point, an SSID must be configured for a Wi-Fi
interface to operate.
In order to forward packets to and from a Wi-Fi interface, it must be bridged to a configured
Ethernet interface. The Wi-Fi interface and Ethernet interface must be in the same Bridge
instance.
If a DHCP server is required to run on the Wi-Fi interface, the DHCP server instance
corresponding bridged Ethernet interface should be configured.
In some cases it may be necessary to bridge multiple Ethernet instances to a single Wi-Fi instance.
If this is required, only one Ethernet instances is should be configured.
Enable this Wi-Fi interface
The Wi-Fi interface can be enabled or disabled.
Description
A descriptive name for the Wi-Fi interface to make it easier to identify.
SSID
When the Wi-Fi interface is configured to be an Access Point, this is the SSID that is advertised
to the Wi-Fi clients to.
When the Wi-Fi interface is configured to be a Client, this is the SSID of the Access Point you
wish to connect to.
Mode
The Wi-Fi interface can run in various modes. The options are:
Access Point
Client
Rogue Detection(Scan for unauthorised Access Points)
This Wi-Fi interface is a member of Bridge instance n and therefore bridged to the following
interfaces.
When the Wi-Fi interface is configured to be an Access Point, in order to forward packets to
and from the Wi-Fi interface it must be bridged with an Ethernet interface using a Bridge
instance.
Interface
Interfaces that are currently members of the selected Bridge instance. Note that multiple Wi-Fi
interfaces can be members of the same Bridge instance.
Link this Wi-Fi client interface with Ethernet n
When the Wi-Fi interface is configured to be a client, it must be bridged to a particular Ethernet
interface.
This Wi-Fi rogue scanner will use Ethernet n
When the Wi-Fi interface is configured to be a rogue scanner, it uses the selected Ethernet
interface.

Table of Contents

Related product manuals