Configure Wi-Fi interfaces
Digi TransPort User Guide 185
Wi-Fi Security
This section is used to configure the security settings for the Wi-Fi interface.
If you are using multiple Wi-Fi interfaces at the same time, the interfaces need to use the same
security settings (except for the pre-shared key (PSK)). The only alternative is that the Wi-Fi is used
with no security.
Use the following security on this Wi-Fi interface
This parameter selects the security that is used on this Wi-Fi interface. The options are:
•None
•WEP
• WPA-PSK, also known as WPA Personal
• WPA2-PSK, also known as WPA2 Personal
• WPA-RADIUS, also known as WPA Enterprise
• WPA2-RADIUS, also known as WPA2 Enterprise
WEP Settings
The various WEP security settings for both Access Point and Client modes.
WEP Key size
The WEP key size to use.
WEP Key index
The WEP key index number. This needs to match the index selected on the connecting Wi-Fi
clients or Access Points that this router wishes to connect to.
WEP Key / Confirm WEP Key
If the WEP key size is 64 bits, the key should be 5 characters long. If the WEP key size is 128 bits,
the key should be 13 characters long.
WPA-PSK / WPA2-PSK
The various WPA-PSK / WPA2-PSK security settings for both Access Point and Client modes.
WPA Encryption
This parameter specifies the encryption algorithm to use. The options are:
•TKIP
•AES (CCMP)
WPA pre-shared key / Confirm WPA pre-shared key
The pre-shared key (PSK) to use. It must be between 8 and 63 characters long.
WPA-RADIUS / WPA2-RADIUS
The various WPA-RADIUS / WPA2- RADIUS security settings for both Access Point and Client
modes.
To Next Page
Loading...
