Configure Wi-Fi interfaces
Digi TransPort User Guide 187
The following table details the authentication and encryption algorithms and the CLI commands
needed to configure them.
Network
Authentication Data Encryption CLI Commands
Open Disabled wifinode 0 security none
Shared Disabled Not supported
Open WEP wifinode 0 security wep
wifinode 0 weptype open
wifinode 0 wepkeylen <64 | 128>
wifinode 0 wepkeyindex <1..4>
wifinode 0 sharedkey <5 or 13 char key>
Shared WEP wifinode 0 security wep
wifinode 0 weptype sharedkey
wifinode 0 wepkeylen <64 | 128>
wifinode 0 wepkeyindex <1..4>
wifinode 0 sharedkey <5 or 13 char key>
WPA TKIP wifinode 0 security wparadius
wifinode 0 wpatype tkip
wifinode 0 radiuscfg 1
WPA2 TKIP wifinode 0 security wpa2radius
wifinode 0 wpatype tkip
wifinode 0 radiuscfg 1
WPA-PSK TKIP wifinode 0 security wpapsk
wifinode 0 wpatype tkip
wifinode 0 sharedkey <8..63 char key>
WPA2-PSK TKIP wifinode 0 security wpa2psk
wifinode 0 wpatype tkip
wifinode 0 sharedkey <8..63 char key>
WPA AES wifinode 0 security wparadius
wifinode 0 wpatype aes
wifinode 0 radiuscfg 1
WPA2 AES wifinode 0 security wpa2radius
wifinode 0 wpatype aes
wifinode 0 radiuscfg 1
To Next Page
Loading...
